I only use a carving knife to cut the hole in the top. For the features I used various implements to make the outlines and then a paring knife for the finishing cuts. I was thinking of using a drill, but the largest bit I have is a spade bit that can only make holes an inch wide, which was too small.
The Premium Member about 9 hours ago
Perfect.
Musashi about 8 hours ago
That is a very Nancy solution.
Rob Nobody about 7 hours ago
Looks gourd to me.
some idiot from R'lyeh Premium Member about 6 hours ago
I refuse to believe Fritzi has only one carving knife.
Aimless Melissa about 4 hours ago
Very creative!
scpandich about 2 hours ago
I only use a carving knife to cut the hole in the top. For the features I used various implements to make the outlines and then a paring knife for the finishing cuts. I was thinking of using a drill, but the largest bit I have is a spade bit that can only make holes an inch wide, which was too small.
Chris 38 minutes ago
well at least there’s a face on it. :j